Owner's manual

60 Chapter 2 Installation
312755-G Rev 00
2 Replace the 8010co chassis bezel.
a Set the notch (on both ends of the 312096-A bezel) into the tabs on the
chassis (Figure 42).
b Lift the top of the bezel up, and then align the captive screws with the
holes in the chassis.
c Using a Phillips screwdriver, tighten the 2 captive screws to secure the
bezel to the chassis.
d Replace the bezel on the second chassis, if installed.
Figure 42 Replacing the 8010co chassis 312096-A bezel
3 Go to the next section, “Installing shelf alarm cables” on page 61.
Fail
Pass
Fail
Pass
10434FA
Bottom bezel