Owner's manual

46 Chapter 2 Installation
312755-G Rev 00
12 Secure the power supply in bay 1 of the lower chassis (Figure 29).
a Use the power supply handle to push the power supply firmly into bay 1.
b Push the extractor lever down to lock the power supply in place.
c Tighten the two power supply retaining screws.
Figure 29 Replacing the power supply
13 Perform steps 3 through 12 for each power supply in the system configuration,
including the upper shelf chassis, if installed.
Use the shorter, 90-inch power cables for upper shelf power supplies.
14 After all power supplies are cabled, go to the next section,“Routing power
supply cables to the BIP” on page 47.
10432FB
+DC
-DC
+DC
-DC
+D
C
-D
C