Owner's manual

Chapter 2 Installation 45
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
10 Attach the lug end of a 125-inch power supply cable to the negative terminal
on the power supply (Figure 27).
Use a 7/16-inch hex wrench to fasten the hardware in the correct order.
Figure 27 Attaching the negative lead
11 Replace the plastic safety cover on the power supply (Figure 28).
Figure 28 Replacing the plastic safety cover on the power supply
+DC
-DC
4
3
2
1
1 = Two-hole crimp lug
2 = Lock washer (x 2)
3 = Hex nut (x 2)
4 = Negative lead wire
10430FA
-DC
+DC
10431FA