Owner's manual

Chapter 2 Installation 41
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
3 Loosen the 2 retaining screws on the power supply located in bay 1 in the
lower chassis (Figure 20).
Figure 20 Loosening the power supply retaining screws
4 Lift the extractor lever to disconnect the power supply from the backplane
connector, and then pull the power supply partially out of the chassis
(Figure 21).
Figure 21 Disconnecting the power supply from the chassis backplane
10424FA
+DC
-DC
+DC
-DC
+DC
-DC
10425FA
+DC
-DC
+DC
-DC
+D
C
-D
C