Owner's manual

Chapter 2 Installation 37
Installing the Breaker Interface Panel for the Ethernet Routing Switch 8010co Chassis
To install the BIP:
1 Remove the plastic back cover from the BIP terminal block (Figure 16).
Figure 16 Removing the plastic back cover from the BIP
2 Position the BIP in the uppermost position in the rack and align the holes in
the mounting bracket with the holes in the rack.
3 Insert 2 screws, appropriate for your rack type, into each mounting bracket
and tighten them (Figure 17).
Figure 17 Installing the BIP in the rack
4 After the BIP is secured in the rack, go to the next section, “Connecting cables
to the chassis power supplies” on page 38.
Caution: The BIP weighs 33.9 lbs (15.4 kg). The next step requires two
persons to mount the BIP in the rack.
10421EA
1 = Back cover (plastic)
2 = Cover screws (x 4)
2
32
PS (+)
Lower Shelf
PS (+)
Upper Shelf
PS (-)
Lower Shelf
PS (-)
Upper Shelf
A/B Input Feed
Returns
– 48 VDC
A/B Input Feeds
1321 321321 A
2
A
1
B
1
B
2
1
2
10378FB
P
O
W
E
R
C
R
IT
IC
A
L
M
A
J
O
R
M
IN
O
R