User Guide

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches

14 300855-C Rev. 00

6. Set up the RAC so that addresses are on the DS0s.

admin: wan 1

admin: set wan=1 ds0=all remote_address

admin: reset wan

Task 9: Reboot the RAC

After making all the configuration changes, you must reboot the RAC for the

changes to take effect. After you reboot the RAC:

1. Connect the cables to the WAN interface ports on the front (Model 5399)

or back (Model 8000) of the RAC.

2. Test the RAC by dialing into it.

Task 10: Customizing the RAC

After installing and booting the RAC, you can customize RAC parameters (for

example security or port parameters) using one of the following tools:

• CLI interface (see Managing Nortel Networks 5399 and 8000 Access Switches

Using Command Line Interfaces)

• Config Utility (see Installing and Administering the Config Utility and the

Config Utility online Help system)

Roadmap

The roadmap provides a series of tasks that you must perform in sequential order

to install, configure, and boot a RAC. Refer to the specified documentation for

detailed instructions. The roadmap can be divided into two distinct sections:

installation and configuration, and customization.

Note: IP addresses are incremented from the starting IP address using an

increment of 1. Addresses will be applied on all DS0s and will be used at

random as the DS0s are used at random. Addresses are assigned to users once

they dial in.