User Guide

Quick-Start Guide
300855-C Rev. 00 13
7.
Leave cli security off so you can access the RAC from the console.
admin: set port cli_security n
8.
Set vcli security.
admin: set annex vcli_security y
9.
Reboot the RAC for the configuration changes to take effect.
admin: quit
annex# boot
10.
After the RAC is rebooted, try to log on to the RAC through a telnet
session. If security is working you may go ahead and set cli security using
the following admin command:
admin: set port cli_security y
PPP Setup
To set up PPP security, perform the following:
1. Log on to the RAC as superuser and run admin.
2. Set PPP security.
admin: set port slip_ppp_security y
3.
Set PPP security protocol.
admin: set port ppp_security_protocol < security protocol > (pap or chap)
4.
Enable security for terminal dial-in users.
admin: set port cli_security y
5.
Set the RAC for PPP callers only.
admin: set port mode ppp
admin: reset port