User Guide

Quick-Start Guide
300855-C Rev. 00 7
Set the Operating Image
The default operating image is shipped with the RAC and is stored in flash
memory. Verify or set the operating image as follows:
1. At the ROM monitor prompt, enter image and respond to the prompts as
shown in the example. To accept the default shown in brackets, press the
Return key.
monitor:: image
Enter Image name [(ip) “oper.64.enet”, “OPER_64_ENET.SYS”]::
Enter TFTP Load Directory[““]::
Enter TFTP Dump path/filename::
192.9.200.62.dump
2.
After you enter the image name, enter im -d to verify the operating
image.
3. After you verify the operating image, set the interface sequence.
Configure the Interface Sequence
The interface sequence determines the order or method in which the RAC boots.
You can configure the RAC for network, self-boot, or both. To set the sequence:
1. At the ROM monitor prompt, enter seq. The system responds:
Enter a list of 1 to 4 interfaces to attempt to use for
downloading code or upline dumping. Enter them in the order they
should be tried, separated by commas or spaces. Possible
interfaces are:
Ethernet: net
SELF: self
Enter interface sequence [net]::
2.
After you enter the sequence, enter seq -d to verify the interface
sequence.
Note: If the RAC is configured for self-boot, copy the configuration
(config.annex) file from the server to the RAC using FTP. Do this after you
boot the RAC.