User Guide

38 Configuration
6
Enter the Management IP address (MIP) of the existing cluster.
Provide the Management IP address of the cluster to which you
want to join the new SNAS. To check the Management IP of an
existing cluster, connect to the cluster and use the /cfg/sys/cur
command.
7
Provide the correct admin user password.
—End—
The SNAS that is joined to the cluster automatically picks up all configuration
data from an installed SNAS in the cluster.
Wait until the Setup utility gets finished.
The login prompt appears.
Log in as admin to continue to configure the SNAS cluster using the CLI
or the BBI.
Enabling the browser-based interface
The SNAS browser-based interface (BBI) is not immediately available for
use when the device is first commissioned. The BBI can be enabled to
work over HTTP, HTTPS, or both protocols. It is recommended the default
ports of 80 (HTTP) and 4443 (HTTPS) be changed when it comes to
device management. HTTP and HTTPS client traffic is connected through
these default ports and if used in device management cannot be available
to service requests.
Nortel Secure Network Access
Installation — Quick Start Switch 4070
NN47230-303 01.01 Standard
2.0 28 July 2008
Copyright © 2008, Nortel Networks
.