User Guide

Cabling the device 31

Procedure steps

Step Action

Prepare either an ASCII terminal or a computer running terminal

emulation software to serve as the command device.

Conﬁgure the terminal or computer with the following parameters:

Serial connection parameters

Parameter Value

Baud Rate

9600

Data Bits

Parity None

Stop Bits

Flow Control None

Connect one end of the serial cable to the terminal or computer.

Connect the other end of the serial cable to the serial connector

located at the rear of the device.

Proceed with establishing the console connection.

—End—

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008