User Guide

26 Installation

Check

Accessory Use to

copper network

interface card

Connect the network cables.

Console cable Establish a console connection

to the device.

—End—

Installing an NSNA device into a rack

Install an NSNA in a standard equipment rack.

Prerequisites for installing an NSNA into a rack

• Do not install the device in the network equipment racks

The following procedure describes how to rack-mount the device. Observe

all safety and precautionary warnings in this procedure. Review Safety and

installation precautions before proceeding with the installation process.

To install the Nortel Secure Network Access Switch, perform the following

tasks. Throughout the following procedure, bold numbers in brackets are

presented. These correspond with the numbers in the step illustration to

provide a visual reference for the installation procedure steps.

Procedure steps

Step Action

Hold the left and right slide rails and separate them from the other

device hardware. Take one slide rail and push outward on the slide

rail latch (1) and pull the latch back to open the slide rail (2). The

latch catches to stay open. Repeat the procedure for the other end

of the slide rail and then again for the other slide rail provided.

Nortel Secure Network Access

Installation — Quick Start Switch 4070

NN47230-303 01.01 Standard

2.0 28 July 2008