- Nortel Ethernet Routing Switch Owner's Manual

Basic navigation 91

logout

The logout command is in all command modes.

The logout command has no parameters or variables.

enable command

The enable command changes the command mode from User EXEC to

Privileged Exec mode. The syntax for the enable command is:

enable

The enable command is executed in the User Exec command mode.

The enable command has no parameters or variables.

conﬁgure command

The configure command moves you to the Global Conﬁguration (conﬁg)

command mode and identiﬁes the source for the conﬁguration commands.

The syntax for the configure command is:

configure {terminal|network}

The configure command is executed in the Privileged EXEC command

mode.

Table 11 "conﬁgure command parameters and variables" (page

91) describes the parameters and variables for the conﬁgure command.

Table 11

conﬁgure command parameters and variables

Parameters and

variables

Description

terminal | network

Specifies the source for the configuration commands for the

Ethernet Routing Switch 2500 Series:

terminal—a you to enter Global Configuration command

mode to enter configuration commands network—lets you

set up parameters for auto-loading a script at boot-up or for

loading and executing a script immediately

interface command

The interface command moves you to the Interface Conﬁguration

(conﬁg-if) command mode. The syntax for the interface command is:

interface FastEthernet <portlist>

Nortel Ethernet Routing Switch 2500 Series

Overview — System Conﬁguration

NN47215-500 (323162-B) 02.02 Standard

4.1 19 November 2007