- Nortel Ethernet Routing Switch Owner's Manual

Displaying topology information using Device Manager 279
3 Type the number of minutes to shift the clock in the Offset box.
4
Select the StartYear, StartMonth, StartDate, StartHour, and type
the StartMinutes to define when to switch the clock to daylight
saving time.
5 Select the EndYear, EndMonth, EndDate, EndHour, and type the
EndMinutes (if applicable) to define when to switch the clock back
to normal time. If you want to keep the same daylight saving time
changeover dates, you can set the EndYear to a year in the future.
6
Click Enabled to enable daylight savings time.
7
Click Apply.
—End—
Displaying topology information using Device Manager
This section describes diagnostic information available in Device Manager
on the following tabs:
•
"Topology tab" (page 279)
•
"Topology Table tab" (page 280)
Topology tab
To view topology information, use the following procedure:
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.