- Nortel Ethernet Routing Switch Owner's Manual

238 Ethernet port management using the CLI
Parameters and
variables
Description
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
10|100|1000|auto
Sets speed to:
•
10—10 Mb/s
•
100—100 Mb/s
•
1000—1000 Mb/s or 1 GB/s
•
auto—autonegotiation
ATTENTION
When you set the port speed for autonegotiation, ensure that the other side of
the link is also set for autonegotiation.
default speed command
The default speed command sets the speed of the port to the factory
default speed. The syntax for the default speed command is:
default speed [port <portlist>]
The default speed command is executed in the Interface Configuration
command mode.
Table 97 "default speed command parameters and variables" (page
238) describes the parameters and variables for the default speed
command.
Table 97
default speed command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to set the speed to factory
default. Enter the port numbers you want to set.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.