- Nortel Ethernet Routing Switch Owner's Manual

Naming ports 235
Table 92
no shutdown command parameters and variables
Parameters and
variables
Description
line <portlist>
Specifies the port numbers to enable. Enter the port
numbers you want to disable.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
Naming ports
You can name a port using the CLI. This section covers the following
commands:
•
"name command" (page 235)
•
"no name command" (page 236)
•
"default name command" (page 236)
name command
The name command lets you name ports or to change the name. The
syntax for the name command is:
name [port <portlist>] <LINE>
The name command is executed in the Interface Configuration command
mode.
Table 93 "name command parameters and variables" (page 235) describes
the parameters and variables for the name command.
Table 93
name command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the port numbers to name.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.