- Nortel Ethernet Routing Switch Owner's Manual

224 System configuration using the CLI
Table 86 "default lldp status command parameters and variables" (page
224) describes the parameters and variables for the default lldp status
command.
Table 86
default lldp status command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the ports affected by the command.
show lldp command
The show lldp command displays configuration data for LLDP. The syntax
for the show lldp command is:
show lldp [local-sys-data] [mgmt-sys-data] [pdu-tlv-size]
[stats]
The show lldp command is executed in the User Exec command mode.
Table 87 "show lldp command parameters and variables" (page
224) describes the parameters and variables for the show lldp command.
Table 87
show lldp command parameters and variables
Parameters and
variables
Description
local-sys-data Displays local LLDP system data.
mgmt-sys-data Displays LLDP management data.
pdu-tlv-size Displays 802.1ab tlv in pdu.
stats
Displays LLDP statistics.
Figure 78 "show lldp local-sys-data command output" (page 225) displays
the output from the show lldp local-sys-data command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.