- Nortel Ethernet Routing Switch Owner's Manual

Configuring LLDP using the CLI 223
The lldp status command is executed in the Interface Configuration
command mode.
Table 84 "lldp status command parameters and variables" (page
223) describes the parameters and variables for the lldp status command.
Table 84
lldp status command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the ports affected by the command.
rxOnly
txAndRx
txOnly
Enables LLDPU receive only.
Enables LLDPU transmit and receive.
Enables LLDPU transmit only.
no lldp status command
The no lldp status command disables 802.1ab on ports. The syntax
for the no lldp status command is:
no lldp [port <portlist>] status
The no lldp status command is executed in the Interface Configuration
command mode.
Table 85 "no lldp status command parameters and variables" (page
223) describes the parameters and variables for the no lldp status command.
Table 85
no lldp status command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the ports affected by the command.
default lldp status command
The default lldp status command sets the LLDPU transmit and
receive status on specified ports to its default value (txAndRx). The syntax
for the default lldp status command is:
default lldp [port <portlist>] status
The default lldp status command is executed in the Interface
Configuration command mode.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.