- Nortel Ethernet Routing Switch Owner's Manual

Configuring LLDP using the CLI 217
Figure 76 "show autotopology settings command output" (page 217) displays
a sample output of the show autotopology settings command.
Figure 76
show autotopology settings command output
show autotopology nmm-table
The show autotopology nmm-table command displays information
about the network management module (NMM) table. The syntax for the
show autotopology nmm-table command is:
show autotopology nmm-table
The show autotopology nmm-table command is executed in the
Privileged EXEC command mode.
The show autotopology nmm-table command has no parameters
or variables.
Figure 77 "show autotopology nmm-table command output" (page
217) displays a sample output of the show autotopology nmm-table
command.
Figure 77
show autotopology nmm-table command output
Configuring LLDP using the CLI
You can enable the LLDP using the CLI. For more information about LLDP,
see "Link Layer Discovery Protocol (IEEE 802.1ab)" (page 74). This section
covers the following commands:
•
"lldp command" (page 218)
•
"default lldp command" (page 219)
•
"lldp config-notification command" (page 219)
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.