- Nortel Ethernet Routing Switch Owner's Manual

Setting time on network elements using Simple Network Time Protocol 211
Table 71
no sntp server command parameters and variables
Parameters and
variables
Description
<primary|secondary>
Enter the NTP server you want to clear:
•
primary—the IP address for the primary NTP
server
•
secondary—the IP address for the secondary NTP
server
sntp sync-now command
The sntp sync-now command forces a manual synchronization with the
NTP server.
ATTENTION
You must have SNTP enabled before this command can take effect.
The syntax for the sntp sync-now command is:
sntp sync-now
The sntp sync-now command is executed in the Global Configuration
command mode.
The sntp sync-now command has no parameters or variables.
sntp sync-interval command
The sntp sync-interval command specifies recurring synchronization
with the NTP server in hours relative to initial synchronization. The syntax
for the sntp sync-interval command is:
sntp sync-interval <0-168>
The sntp sync-interval command is executed in the Global
Configuration command mode.
Table 72 "sntp sync-interval command parameters and variables" (page
212) describes the parameters and variables for the sntp sync-interval
command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.