- Nortel Ethernet Routing Switch Owner's Manual

196 System configuration using the CLI
Setting boot parameters
You can reboot the switch and configure BootP. The topics covered in this
section are:
•
"boot command" (page 196)
•
"ip bootp server command" (page 196)
•
"no ip bootp server command" (page 197)
•
"default ip bootp server command" (page 197)
boot command
The boot command performs a soft-boot of the switch. The syntax for
the boot command is:
boot [default]
The boot command is executed in the Privileged EXEC command mode.
Table 60 "boot command parameters and variables" (page 196) describes
the parameters and variables for the boot command.
Table 60
boot command parameters and variables
Parameters and
variables
Description
default Restores switch to factory-default settings after
rebooting.
ATTENTION
When you reset to factory defaults, the last reset count and reason for last reset
will not be set to factory defaults.
ip bootp server command
The ip bootp server command configures BootP on the current
instance of the switch or server. The syntax for the ip bootp server
command is:
ip bootp server {default-ip|last|disable|always}
The ip bootp server command is executed in the Global Configuration
command mode.
Table 61 "ip bootp server command parameters and variables" (page
197) describes the parameters and variables for the ip bootp server
command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.