- Nortel Ethernet Routing Switch Owner's Manual

Customizing your system 193
Customizing your system
You can customize your system using the CLI commands described in this
section. This section covers the following topics:
• "Setting the terminal" (page 193)
•
"Displaying system information" (page 195)
•
"Setting boot parameters" (page 196)
• "Setting TFTP parameters" (page 197)
•
"Customizing the opening banner" (page 200)
Setting the terminal
You can view the terminal settings, set them to default settings, or customize
the terminal settings. This sections contains information about the following
commands:
•
"show terminal command" (page 193)
•
"terminal command" (page 193)
show terminal command
The show terminal command displays the current serial port information,
which includes connection speed, as well as the terminal width and length
in number of characters. The syntax for the show terminal command is:
show terminal
The show terminal command is executed in the User Exec command
mode.
The show terminal command has no parameters or variables.
Figure 63 "show terminal command output" (page 193) shows the output
from the show terminal command.
Figure 63
show terminal command output
terminal command
The terminal command configures the settings for the terminal. These
settings are transmit and receive speeds, terminal length, and terminal
width. The syntax of the terminal command is:
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.