- Nortel Ethernet Routing Switch Owner's Manual

Configuring PoE port parameters using the CLI 163
Parameters and
variables
Description
ATTENTION
If you omit this parameter, the system uses the
port entered with the interface FastEthernet
command.
low | high |
critical
Sets the port priority as:
•
low
•
high
•
critical
ATTENTION
The default setting is low. When two ports have the
same priority and one must be shut down, the port
with the higher port number is shut down first.
poe poe-limit command
The poe poe-limit command sets the maximum power allowed to a
port. The syntax for the poe poe-limit command is:
poe poe-limit [port <portlist>] <3-16>
The poe poe-limit command is executed in the Interface Configuration
command mode.
Table 39 "poe poe-limit command parameters and variables" (page
164) describes the parameters and variables for the poe poe-limit command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.