- Nortel Ethernet Routing Switch Owner's Manual

162 Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWR
Table 37 "poe poe-shutdown command parameters and variables" (page
162) describes the parameters and variables for the poe poe-shutdown
command.
Table 37
poe poe-shutdown command parameters and variables
Parameters and
variables
Description
port <portlist>
Enter the port numbers on which you want to disable
power.
The default value is enabled.
ATTENTION
If you omit this parameter, the system uses the
port entered with the interface FastEthernet
command.
poe poe-priority command
The poe poe-priority command lets you set the power priority for each
port to low, high, or critical. The system uses the port power priority settings
to distribute power to the ports depending on the available power budget.
The syntax for the poe poe-priority command is:
poe poe-priority [port <portlist>] {low | high | critical}
The poe poe-priority command is executed in the Interface
Configuration command mode.
Table 38 "poe poe-priority command parameters and variables" (page
162) describes the parameters and variables for the poe poe-priority
command.
Table 38
poe poe-priority command parameters and variables
Parameters and
variables
Description
port <portlist>
Enter the port numbers on which you want to disable
power.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.