User's Manual

109
Nortel WLAN Access Point 2332 Series Installation Guide
AP technical specifications
This appendix lists the technical specifications for the Nortel 2332 Series access points. Table 6 lists the mechanical and
compliance specifications. Table 7 on page 110, Table 8 on page 111, and Table 9 on page 111 list the radio specifica-
tions. Table 10 on page 112 lists the MAC address allocation scheme.
(For specifications for the WSS, see the Nortel
WLAN-Security Switch 2300 Series Configuration Guide.)
Note. The 2332 Series access points are designed and approved to be used only with
Nortel WLAN—Security Switch (WSS) models 2360/2361, and 2350. (The 2380 and 2382
does not directly connect to the AP.)
Note. The AP radios are disabled by default and can be enabled only by the system
administrator using the WLAN Management softwareapplication or the WSS’s
command-line interface (CLI).
Note. The radio frequency band, operating channels, and transmit power depend on the
country of operation specified by the system administrator using WLAN Management
software or the WSS’s CLI.
Table 6: AP Mechanical and Compliance Specifications
Specification Description
Size Diameter: 16.76 cm (6.6 inches)
Height: 6.1 cm (2.4 inches)
Weight Without mounting bracket: 0.45 kg (16 ounces)
With mounting bracket: 0.5 kg (17.5 ounces)
Operating Temperature 0° C to +50° C (32° F to 122° F)
Storage Temperature -20° C to +70° C (-4° F to +158° F)
Humidity 10% to 95% noncondensing
Power over Ethernet (PoE) 42 VDC to 57 VDC (46 VDC nominal)
IEEE 802.3af
Status indicators Health/WSS and radio LEDs
(For descriptions of the LEDs, see “Status LEDs” on page 28.)
Wired network ports Two RJ-45 ports for 10/100BASE-T Ethernet and Power over Ethernet
(PoE) for the 2332 Series only.