User's Manual

9
Nortel WLAN Access Point 2332 Series Installation Guide
Deployment Statement
This product is certified for indoor deployment only. Do not install or use this product outdoors.
Dynamic Frequency Selection (DFS) in the 5.0 GHz UNII bands
The 2332 Series access point has been prohibited, via software, from operating in the 5250 to 5350 MHz and
5470 to 5725 MHz frequency bands for the US and Canada because it cannot meet the DFS requirements as outlined in
the rules of the FCC for Part 15, Subpart E that come into force on July 20, 2007.
The 2332 Series and 2332 Series access points will not be marketed or sold in the US and Canada after July 20, 2007
because they are not compliant with the FCC Part 15, Subpart E rules.
Canadian IC Statement
Operation is subject to the following two conditions in Canada:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired operation of the
device
To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is intended to
be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is
installed outdoors is subject to licensing and not supported by the WLAN Access Point 2332 Series.
Because high power radars are allocated as primary users (meaning they have priority) in the 5250-5350 MHz band,
these radars could cause interference and/or damage to license exempt WLAN devices.
European Union and European Free Trade Association (EFTA)
Regulatory Compliance
This equipment may be operated in the countries that comprise the member countries of the European Union and the
European Free Trade Association. These countries, listed in the following paragraph, are referred to as The European
Community throughout this document:
AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA, FINLAND, FRANCE,
GERMANY, GREECE, HUNGARY, IRELAND, ITALY, LATVIA, LITHUANIA, LUXEMBOURG, MALTA,
NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN, SWEDEN, UNITED
KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND
The WLAN Access Point 2332 Series communicates with a Nortel Networks WLAN - Security Switch using a standard
CAT-5 (Category 5) or higher 10/100 Mbps twisted pair Ethernet cable to provide wireless local area networking
(WLAN) capabilities. The WLAN Access Point 2332 Series includes one 802.11a and one
802.11b/g radio and two 802.11a and two 802.11b/g omnidirectional internal antennas. In addition, the 2332 Series
access point can use optional factory-supplied external omnidirectional and/or directional high-gain antennas, one per
the 802.11b/g and one per the 802.11a radios, as described in the external antenna section of the WLAN Access Point
2332 Series Installation Guide. When using the external antennas, connect them to the reverse-polarity R-SMA
connectors located on the side of the WLAN Access Point 2332 Series.
Declaration of Conformity
Marking by this symbol
!