User's Manual

46 Installing and connecting an 2332 Series
NN47250-302 (324136-A Version 01.02)
Figure 20. Step 10—Locking the Bracket
12 To ensure that the AP is fully locked onto the bracket, gently pull down on the access point and attempt to
rotate it from side to side.
If the access point comes off the bracket, relock the device onto the bracket as described in step 11 on
page 40.
13 If the other end of the Cat-5 cable is not already connected and the link activated, then go to “Connecting
an AP to a WSS” on page 53. Otherwise, go to “Verifying AP health” on page 55.
Junction box installation
(For required mounting hardware and tools, see Table 3 on page 36.)
1 Unlock the universal mounting bracket from the AP by inserting the 3-mm or 1/8-inch screwdriver into
the Unlock hole on the AP as shown in Figure 21.
Caution! To avoid damage to the AP’s lock mechanism or electronic
components, do not use excessive force when inserting a tool into the Unlock or
Lock hole.
840-9502-0006
Lock
T-bar