User's Manual

34 Installing and connecting an 2332 Series
NN47250-302 (324136-A Version 01.02)
Additional radio safety advisories
(For translations of these warnings, see “Radio safety warnings” on page 116.)
Cable requirements
Standard Cat-5 Ethernet cabling is required for use with the 2332 Series.
Cat-5 cable with straight-through signaling must be installed at the site before you install an access point. A single
connection requires one cable.
Table 2 lists the pin signals for the 10/100 Ethernet straight-through wiring. Pins 4, 5, 7, and 8 are used when Nortel
Power over Ethernet (PoE) is enabled on the port. RD stands for Receive Data and TD stands for Transmit Data.
Warning! Install this device in such a manner as to maintain a minimum of 20 cm (7.9
inches) separation distance between the radiating element(s) and all persons. This safety
warning conforms with FCC radio frequency exposure limits.
Warning! Do not operate the AP near unshielded blasting caps or in an otherwise
explosive environment unless the device has been modified for such use by qualified
personnel.
Warning! Do not touch or move the AP when the antennas are transmitting or
receiving.
Warning! Before using a wireless device in a hazardous location, consult the local
codes, national codes, and safety directors of the location for usage constraints.
Note. The 2332 Series is intended for indoor use only. Do not install the device nor
operate it outdoors.
Note. To reduce the possibility of connection interference caused by dust, clean the
Cat-5 connector pins before inserting a cable into an AP.