User's Manual
Table Of Contents
- Nortel WLAN-Access Point 2330 Quick Installation Guide
- Copyright © Nortel Networks Limited 2005. All rights reserved.
- Trademarks
- Restricted rights legend
- Statement of conditions
- Canadian IC Statement
- European Community Compliance
- External Antenna Statement
- Contacting Nortel Technical Support
- WLAN-Access Point 2330
- Cable Requirement
- Suspended Ceiling Installation-Flush Ceiling Tiles
- Suspended Ceiling Installation-Drop Ceiling Tiles
- Junction Box Installation
- Solid Wall or Ceiling Installation
- Configuring the AP
Suspended Ceiling Installation—Flush Ceiling Tiles 9
Nortel WLAN—Access Point 2330 Quick Installation Guide
Suspended Ceiling Installation—Flush Ceiling Tiles
This procedure applies to T-bars that are 23.9 mm (15/16 inches) wide. For a 14.2-mm (9/16-inch) or 15.9-mm (5/8-inch)
T-bar, go to “Suspended Ceiling Installation—Drop Ceiling Tiles” on page 11.
1 Use the mounting template to cut a hole for the Cat 5 cable.
2 Remove the mounting bracket from the 2330 access point.
3 Attach the mounting bracket to the T-bar clamp.
Mounting
bracket
Mounting
template
Access
point
840-9502-0089
840-9502-0011
840-9502-0008
T- b a r
(Viewed from above ceiling tiles, looking down.)
840-9502-0005
Universal mounting
bracket
Port connector
opening
T- b a r
Universal mounting bracket
840-9502-0004
Port connector
opening