User Guide

298 Configuring RF Auto-Tuning
320657-A
Changing Power Tuning Settings
Enabling Power Tuning
RF Auto-Tuning for power is disabled by default. To enable or disable the feature for all radios in a radio
profile, use the following command:
set radio-profile name auto-tune power-config {enable | disable}
To enable power tuning for radios in the rp2 radio profile, type the following command:
23x0# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
Changing the Power Tuning Interval
The default power tuning interval is 300 seconds. You can change the interval to a value from 1 to 65535
seconds. To change the power tuning interval, use the following command:
set radio-profile name auto-tune power-interval seconds
To set the power tuning interval for radios in radio profile rp2 to 240 seconds, type the following command:
23x0# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
Changing the Power Backoff Interval
The default power backoff interval is 10 seconds. You can change the interval to a value from 0 to 65535
seconds. To change the power backoff interval, use the following command:
set radio-profile name auto-tune power-backoff-timer seconds
To change the power-backoff interval for radios in radio profile rp2 to 15 seconds, type the following
command:
23x0# set radio-profile rp2 auto-tune power-backoff-timer 15
success: change accepted.
Changing the Maximum Default Power Allowed On a Radio
By default, the maximum default power level that RF Auto-Tuning can set on a radio is the same as the
maximum power level allowed for the country of operation. To change the maximum default power level that
RF Auto-Tuning can assign, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} auto-tune max-power power-level
The power-level can be a value from 1 to 20.