Hub/Switch Reference Guide

VLAN Commands 99
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Examples To display all tunnels from a WSS to other switches in the Mobility Domain, type the following
command.
WSS# show tunnel
VLAN Local Address Remote Address State Port LVID RVID
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng 192.168.14.2 192.168.14.4 DORMANT 1024 4096 130
Table 15 describes the fields in the display.
See Also show vlan config on page 89
show vlan config
Displays VLAN information.
Syntax show vlan config [vlan-id]
Defaults None.
Access All.
Examples The following command displays information for VLAN burgundy:
Table 5: Output for show tunnel
Field Description
VLAN VLAN name.
Local Address IP address of the local end of the tunnel. This is the system IP address of
the WSS where you enter the command.
Remote Address IP address of the remote end of the tunnel. This is the system IP address of
another WSS in the mobility domain.
State Tunnel state:
•Up
•Dormant
Port Tunnel port ID.
LVID Local VLAN ID.
RVID Remote VLAN ID.
vlan-id VLAN name or number. If you do not specify a VLAN, information for
all VLANs is displayed.