Hub/Switch Reference Guide

94 VLAN Commands
NN47250-100 (Version 02.51)
See Also set fdb agingtime on page 78
show fdb count
Lists the number of entries in the forwarding database.
Syntax show fdb count {perm | static | dynamic} [vlan vlan-id]
Defaults None.
Access All.
Examples The following command lists the number of dynamic entries that the forwarding database
contains:
WSS# show fdb count dynamic
Total Matching Entries = 2
See Also show fdb on page 81
show roaming station
Displays a list of the stations roaming to the WSS through a VLAN tunnel.
Syntax show roaming station [vlan vlan-id] [peer ip-addr]
Defaults None.
Access Enabled.
History
perm Lists the number of permanent entries. A permanent entry does not age
out and remains in the database even after a reboot, reset, or power cycle.
static Lists the number of static entries. A static entry does not age out, but is
removed from the database after a reboot, reset, or power cycle.
dynamic Lists the number of dynamic entries. A dynamic entry is automatically
removed through aging or after a reboot, reset, or power cycle.
vlan vlan-id VLAN name or number. Entries are listed for only the specified VLAN.
vlan vlan-id Output is restricted to stations using this VLAN.
peer ip-addr Output is restricted to stations tunnelling through this peer WSS in the
Mobility Domain.
Version 4.0 Old AP MAC field removed.