Hub/Switch Reference Guide

VLAN Commands 87
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Examples The following command removes port 1 from VLAN green:
WSS# clear vlan green port 1
This may disrupt user connectivity. Do you wish to continue? (y/n) [n]y
success: change accepted.
The following command removes port 4, which uses tag value 69, from VLAN red:
WSS# clear vlan red port 4 tag 69
This may disrupt user connectivity. Do you wish to continue? (y/n) [n]y
success: change accepted.
The following command completely removes VLAN marigold:
WSS# clear vlan marigold
This may disrupt user connectivity. Do you wish to continue? (y/n) [n]y
success: change accepted.
See Also
• set vlan port on page 80
• show vlan config on page 89
set fdb
Adds a permanent or static entry to the forwarding database.
Syntax set fdb {perm | static} mac-addr port port-list
vlan vlan-id [tag tag-value]
Defaults None.
Access Enabled.
Usage You cannot add a multicast or broadcast address as a permanent or static FDB entry.
perm Adds a permanent entry. A permanent entry does not age out and remains
in the database even after a reboot, reset, or power cycle.
static Adds a static entry. A static entry does not age out, but is removed from
the database after a reboot, reset, or power cycle.
mac-addr Destination MAC address of the entry. Use colons to separate the octets
(for example, 00:11:22:aa:bb:cc).
port port-list
List of physical destination ports for which to add the entry. A separate
entry is added for each port you specify.
vlan vlan-id
Name or number of a VLAN of which the port is a member. The entry is
added only for the specified VLAN.
tag tag-value VLAN tag value that identifies a virtual port. You can specify a number
from 1 through 4093. If you do not specify a tag value, an entry is created
for an untagged interface only. If you specify a tag value, an entry is
created only for the specified tagged interface.