Hub/Switch Reference Guide

System Services Commands 79
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Table 1: show system output
Field Description
Product Name WSS model number.
System Name System name (factory default, or optionally configured with set system name).
System Countrycode Country-specific 802.11 code required for AP operation (configured with set
system countrycode).
System Location Record of WSS’s physical location (optionally configured with set system
location).
System Contact Contact information about the system administrator or another person to contact
about the system (optionally configured with set system contact).
System IP Common interface, source, and default IP address for the WSS, in dotted decimal
notation (configured with set system ip-address).
System idle timeout Number of seconds WSS Software allows a CLI management session (console,
Telnet, or SSH) to remain idle before terminating the session. (The system idle
timeout can be configured using the set system idle-timeout command.)
System MAC WSS media access control (MAC) machine address set at the factory, in 6-byte
hexadecimal format.
Boot Time Date and time of the last system reboot.
Uptime Number of days, hours, minutes, and seconds that the WSS has been operating
since its last restart.
Fan status Operating status of the three WSS cooling fans:
• OK—Fan is operating.
• Failed—Fan is not operating. WSS Software sends an alert to
the system log every 5 minutes until this condition is
corrected.
Fan 1 is located nearest the front of the chassis, and fan 3 is located nearest the
back.
Temperature Status of temperature sensors at three locations in the WSS:
• ok—Temperature is within the acceptable range of 0° C to
50° C (32° F to 122° F).
• Alarm—Temperature is above or below the acceptable range.
WSS Software sends an alert to the system log every 5 minutes
until this condition is corrected.