Hub/Switch Reference Guide

76 System Services Commands

NN47250-100 (Version 02.51)

See Also

• clear system on page 55

• set system contact on page 62

• set system name on page 66

• show system on page 68

set system name

Changes the name of the WSS from the default system name and also provides content for the CLI prompt, if

you do not specify a prompt.

Syntax

set system name string

Defaults

By default, the system name and command prompt have the same value. The factory

default for both is WSS-mmmm-nnnnnn, where mm is the model number and nnnnnn is the last

6 digits of the 12-digit system MAC address.

Access

Enabled.

Usage

Entering set system name with no string resets the system name to the factory default.

To view the system name string, type the show system command.

Examples

The following example sets the system name to a name that identifies the WSS:

WSS# set system name WSS-bldg3

success: change accepted.

WSS-bldg3#