Hub/Switch Reference Guide

System Services Commands 75
Nortel WLAN—Security Switch 2300 Series Command Line Reference
set system ip-address
Sets the system IP address so that it can be used by various services in the WSS.
Syntax set system ip-address ip-addr
Defaults None.
Access Enabled.
Examples The following command sets the IP address of the WSS to 192.168.253.1:
WSS# set system ip-address 192.168.253.1
success: change accepted.
See Also
• clear system on page 55
• set interface on page 109
• show system on page 68
set system location
Stores location information for the WSS.
Syntax set system location string
Defaults None.
Access Enabled.
Usage You cannot include spaces in the system location string.
To view the system location string, type the show system command.
Examples To store the location of the WSS in the switch’s configuration, type the following
command:
WSS# set system location first-floor-bldg3
success: change accepted.
Caution! Any currently configured Mobility Domain operations cease if you change the
IP address. If you change the address, you must reset the Mobility Domain.
ip-addr IP address, in dotted decimal notation.
string Alphanumeric string up to 256 characters long and blank spaces are accepted.