Hub/Switch Reference Guide

System Services Commands 73
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Examples The following command sets the system contact information to [e-mail]:
23x0#set system contact [e-mail]
success: change accepted.
See Also
• clear system on page 55
• set system location on page 65
• set system name on page 66
• show system on page 68
set system countrycode
Defines the country-specific IEEE 802.11 regulations to enforce on the WSS.
Syntax set system countrycode code
Defaults The factory default country code is None.
Access Enabled.
Usage You must set the system county code to a valid value before using any set ap commands to configure
an Access Point (AP).
Examples To set the country code to Canada, type the following command:
23x0#set system country code CA
success: change accepted.
code For the two-letter country code, refer to the approved list of country
codes "Approved Countries for the WLAN 2300 Series Components"
located at
http://www.nortel.com/support.
Note. For a complete listing of the models in the WLAN Series 2332 and their respective
countries of operation, please visit
http://www.nortel.com/support.
The Series 2332 access point has been region-locked to meet geographic regulatory
restrictions. Each model is associated to a specific regulatory domain and subsequent
country of operation. During installation, the access point model and wireless security
switch regulatory domain must match or the access point will not operate.