Manualshelf

Hub/Switch Reference Guide

ManualsBrandsNortel Networks ManualsSwitch2300 Series
61626364656667686970
System Services Commands 67
Nortel WLAN—Security Switch 2300 Series Command Line Reference
traceroute Print the route packets take to network host
See Also
“Using CLI Help” on page 16
history
Displays the command history buffer for the current CLI session.
Syntax
history
Defaults
None.
Access
All.
Examples
To show the history of your session, type the following command:
WSS> history
Show History (most recent first)
--------------------------------
[00] show config
[01] show version
[02] enable
See Also
clear history on page 54
quickstart
Runs a script that interactively helps you configure a new switch.
(For information, see the “CLI quickstart Command” section of the “WSS Setup Methods” chapter in the Nortel WLAN
Security Switch 2300 Series Configuration Guide.)
set auto-config
Enables a WSS to contact a WLAN Management Software server for its configuration.
Caution! The quickstart command is for configuration of a new switch only. After
prompting you for verification, the command erases the switch’s configuration before
continuing. If you run this command on a switch that already has a configuration, the
configuration will be erased. In addition, error messages such as Critical AP Notice for
directly connected APs can appear.