Hub/Switch Reference Guide

66 System Services Commands
NN47250-100 (Version 02.51)
Examples To clear the location of the WSS, type the following command:
WSS# clear system location
success: change accepted.
See Also
• set system contact on page 62
• set system countrycode on page 63
• set system idle-timeout on page 64
• set system ip-address on page 65
• set system location on page 65
• show config on page 553
• show system on page 68
help
Displays a list of commands that can be used to configure and monitor the WSS.
Syntax help
Defaults None.
Access All.
Examples Use this command to see a list of available commands. If you have restricted access, you see
fewer commands than if you have enabled access. To display a list of CLI commands available at the enabled
access level, type the following command at the enabled access level:
WSS# help
Commands:
-------------------------------------------------------------------------
clear Clear, use 'clear help' for more information
commit Commit the content of the ACL table
copy Copy from filename (or url) to filename (or url)
crypto Crypto, use 'crypto help' for more information
delete Delete url
dir Show list of files on flash device
disable Disable privileged mode
exit Exit from the Admin session
help Show this help screen
history Show contents of history substitution buffer
hit-sample-rate Set NP hit-counter sample rate
load Load, use 'load help' for more information
logout Exit from the Admin session
monitor Monitor, use 'monitor help' for more information
ping Send echo packets to hosts
quit Exit from the Admin session
reset Reset, use 'reset help' for more information
rollback Remove changes to the edited ACL table
save Save the running configuration to persistent storage
set Set, use 'set help' for more information
show Show, use 'show help' for more information
telnet telnet IP address [server port]