Manualshelf

Hub/Switch Reference Guide

ManualsBrandsNortel Networks ManualsSwitch2300 Series
61626364656667686970
System Services Commands 65
Nortel WLAN—Security Switch 2300 Series Command Line Reference
clear prompt
Resets the system prompt to its previously configured value. If the prompt was not configured previously, this command
resets the prompt to its default.
Syntax
clear prompt
Defaults
None.
Access
Enabled.
Examples
To reset the prompt, type the following command:
wildebeest# clear prompt
success: change accepted.
WSS#
See Also
set prompt on page 62. (For information about default prompts, see
“Command Prompts” on page 10.)
clear system
Clears the system configuration of the specified information.
Syntax
clear system [contact | countrycode | idle-timeout | ip-address | location | name]
Defaults
None.
Access
Enabled.
History
Caution! If you change the IP address, any currently configured Mobility Domain
operations cease. You must reset the Mobility Domain.
contact Resets the name of contact person for the WSS to null.
countrycode Resets the country code for the WSS to null.
idle-timeout Resets the number of seconds a CLI management session can remain idle
to the default value (3600 seconds).
ip-address Resets the IP address of the WSS to null.
location Resets the location of the WSS to null.
name Resets the name of the WSS to the default system name, which is WSS-
mm-nnnnnn, where mm is the model number and nnnnnn is the
last 6 digits of the switch’s MAC address.
Version 4.1 Option idle-timeout added.