Hub/Switch Reference Guide

63
Nortel WLAN—Security Switch 2300 Series Command Line Reference
System Services Commands
Use system services commands to configure and monitor system information for a WLAN—Security Switch
(WSS). This chapter presents system services commands alphabetically. Use the following table to located
commands in this chapter based on their use.
Configuration quickstart on page 57
Auto-Config set auto-config on page 57
Display clear banner motd on page 54
set banner motd on page 59
show banner motd on page 67
set confirm on page 60
set length on page 60
System Identification set prompt on page 62
set system name on page 66
set system location on page 65
set system contact on page 62
set system countrycode on page 63
set system idle-timeout on page 64
set system ip-address on page 65
show load on page 67
show system on page 68
clear system on page 55
clear prompt on page 55
Help help on page 56
History history on page 57
clear history on page 54
License set license on page 61