Hub/Switch Reference Guide

Boot Prompt Commands 609
Nortel WLAN—Security Switch 2300 Series Command Line Reference
• next on page 595
test
Displays or changes the state of the poweron test flag. The poweron test flag controls whether a WSS performs a set of
self tests prior to the boot process.
Syntax test [ON | on | OFF | off]
Defaults The poweron test flag is disabled by default.
Access Boot prompt.
Examples The following command displays the current setting of the poweron test flag:
boot> test
The diagnostic execution flag is not set.
See Also boot on page 587
version
Displays version information for a WSS’s hardware and boot code.
Syntax version
Defaults None.
Access Boot prompt.
Usage This command does not list the system image file versions installed in the boot partitions. To display
system image file versions, use the dir or fver command.
Examples To display hardware and boot code version information, type the following command at the boot
prompt:
boot> version
Nortel WSS Bootstrap/Bootloader
Version 1.6.5 Release
Bootstrap 0 version: 1.17 Active
Bootloader 0 version: 1.6.5 Active
Bootstrap 1 version: 1.17
ON Enables the poweron test flag.
on Same effect as ON.
OFF Disables the poweron test flag.
off Same effect as OFF.