Hub/Switch Reference Guide

608 Boot Prompt Commands
NN47250-100 (Version 02.51)
See Also
• change on page 588
• create on page 590
• delete on page 590
• dhcp on page 591
DEVICE Location of the system image file:
• c:—Nonvolatile storage area containing boot
partition 0
• d:—Nonvolatile storage area containing boot
partition 1
• e:—Primary partition of the flash card in the flash
card slot
• f:—Secondary partition of the flash card in the
flash card slot
• boot0—boot partition 0
• boot1—boot partition 1
When the boot type is Network, the device can be one of the
following:
• emac1—Port 1 on a 2350
• emac2—Port 2 on a 2350
• mgmt or tsec0—The 10/100 port labelled Mgmt
on an 2382
HOST IP For network booting, the IP address of the host where the system
image resides
LOCAL IP For network booting, the IP address of the WSS. If the DHCP
option is enabled, this does not need to be specified.
GATEWAY IP For network booting, the default router (gateway) used by the
WSS. If the DHCP option is enabled, this does not need to be
specified.
IP MASK For network booting, the subnet mask. If the DHCP option is
enabled, this does not need to be specified.
FILENAME System image file name.
FLAGS Number representing the bit settings of boot flags to pass to the
booted system image.
OPTIONS String up to 128 bytes of boot options to pass to the booted
system image.
Table 1: Output for show (continued)
Field Description