Hub/Switch Reference Guide

Boot Prompt Commands 605
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also help on page 593
next
Activates and displays the boot profile in the next boot profile slot. (For information about boot profiles, see show on
page 596.)
Syntax next
Defaults None.
Access Boot prompt.
Usage A WSS contains 4 boot profile slots, numbered 0 through 3. This command activates the boot profile
in the next slot, in ascending numerical order. If the currently active slot is 3, the command activates the boot
profile in slot 0.
Examples To activate the boot profile in the next slot and display the profile, type the following command:
boot> next
BOOT Index: 0
BOOT TYPE: c
DEVICE: boot1:
FILENAME: testcfg
FLAGS: 00000000
OPTIONS: run=nos;boot=0
See Also
• change on page 588
• create on page 590
• delete on page 590
• show on page 596
reset
Resets a WSS’s hardware.
Syntax reset
Defaults None.
Access Boot prompt.
Usage After resetting the hardware, the reset command attempts to load a system image file only if other
boot settings are configured to do so.
Examples To immediately reset the system, type the following command at the boot prompt: