Hub/Switch Reference Guide

60 Port Commands
NN47250-100 (Version 02.51)
9 9 up AP enabled 1.44
10 10 up - disabled off
11 11 down - disabled off
12 12 down - disabled off
13 13 down - disabled off
14 14 down - disabled off
15 15 down - disabled off
16 16 down - disabled off
17 17 down - disabled off
18 18 down - disabled off
19 19 down - disabled off
20 20 down - disabled off
21 21 down - disabled invalid
22 22 down - disabled invalid
Table 8 describes the fields in this display.
See Also set port poe on page 39
Table 8: Output for show port poe
Field Description
Port Port number.
Name Port name. If the port does not have a name, the port number is
listed.
Link status Link status of the port:
• up—The port is connected.
• down—The port is not connected.
Port type Port type:
• AP—The port is an access port.
• - (The port is not an AP.)
PoE config PoE state:
• enabled
• disabled
PoE Draw Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled, this field
displays off. For gigabit Ethernet ports, this field displays invalid,
because PoE is not supported on gigabit Ethernet ports.
The value overcurrent indicates a PoE problem such as a short in
the cable.