Hub/Switch Reference Guide

Boot Prompt Commands 599

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Access

Boot prompt.

Usage

After you type the change command, the system interactively displays the current setting

of each parameter and prompts you for the new setting. When prompted, type the new setting, press

Enter to accept the current setting, or type . (period) to change the setting to its default value. To

back up to the previous parameter, type - (hyphen).

For information about each of the boot parameters you can set, see show on page 596.

Examples

The following command enters the configuration mode for the currently active boot

profile, changes the device to boot1, and leaves the other parameters with their current settings:

boot> change

Changing the default configuration is not recommended.

Are you sure that you want to proceed? (y/n)y

BOOT TYPE: [c]

DEVICE: [boot0:]boot1

FILENAME: [default]

FLAGS: [0x00000000]

OPTIONS: [run=nos;boot=0]

The following command enters the configuration mode for the currently active boot profile and configures the

WSS (in this example, a 2350) to boot using a TFTP server:

boot> change

Changing the default configuration is not recommended.

Are you sure that you want to proceed? (y/n)y

BOOT TYPE: [c]> n

DEVICE: [boot0:]> emac1

FILENAME: [default]> bootfile

HOST IP: [0.0.0.0]> 172.16.0.1

LOCAL IP: [0.0.0.0]> 172.16.0.21

GATEWAY IP: [0.0.0.0]> 172.16.0.20

IP MASK: [0.0.0.0]> 255.255.255.0

FLAGS: [0x00000000]>

OPTIONS: [run=nos;boot=0]>