Hub/Switch Reference Guide

596 Boot Prompt Commands
NN47250-100 (Version 02.51)
autoboot
Displays or changes the state of the autoboot option. The autoboot option controls whether a WSS automatically boots a
system image after initializing the hardware, following a system reset or power cycle.
Syntax autoboot [ON | on | OFF | off]
Defaults The autoboot option is enabled by default.
Access Boot prompt.
Examples The following command displays the current setting of the autoboot option:
boot> autoboot
The autoboot flag is on.
See Also boot on page 587
ON Enables the autoboot option.
on Same effect as ON.
OFF Disables the autoboot option.
off Same effect as OFF.