Hub/Switch Reference Guide

Port Commands 59
Nortel WLAN—Security Switch 2300 Series Command Line Reference
show port mirror
Displays the port mirroring configuration.
Syntax show port mirror
Defaults None.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Examples The following command displays the port mirroring configuration on the switch:
WSS# show port mirror
Port 1 is mirrored to port 2
If port mirroring is not configured, the message in the following example is displayed instead:
WSS# show port mirror
No ports are mirrored
See Also
• clear port mirror on page 26
• set port mirror on page 37
show port poe
Displays status information for ports on which Power over Ethernet (PoE) is enabled.
Syntax show port poe [port-list]
Defaults None.
Access All.
Examples The following command displays PoE information for all ports on a 22-port WSS:
WSS# show port poe
Link Port PoE PoE
Port Name Status Type config Draw
==============================================================================
1 1 up - disabled off
2 2 down - disabled off
3 3 down - disabled off
4 4 down - disabled off
5 5 down - disabled off
6 6 down - disabled off
7 7 down - disabled off
8 8 down - disabled off
port-list List of physical ports. If you do not specify a port list, PoE information is
displayed for all ports.