Hub/Switch Reference Guide

System Log Commands 589
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Examples The following command enables mark messages:
WSS# set log mark enable
success: change accepted.
See Also show log config on page 581
set log trace mbytes
This command is deprecated in WSS Software Version 4.0.
show log buffer
Displays system information stored in the nonvolatile log buffer or the trace buffer.
Syntax show log buffer [{+|-}number-of-messages] [facility facility-name] [matching
string] [severity severity-level]
buffer Displays the log messages in nonvolatile storage.
+|-number-of-messages Displays the number of messages specified as follows:
• A positive number (for example, +100), displays
that number of log entries starting from the oldest
in the log.
• A negative number (for example, -100) displays
that number of log entries starting from newest in
the log.
facility facility-name Area of WSS Software that is sending the log message. Type a
space and a question mark (?) after show log buffer facility for a
list of valid facilities.
matching string Displays messages that match a string—for example, a username
or IP address.