Hub/Switch Reference Guide

System Log Commands 587
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults
• Events at the error level and higher are logged to the WSS console.
• Events at the error level and higher are logged to the WSS system buffer.
• Trace logging is enabled, and debug-level output is stored in the WSS trace buffer.
Access Enabled.
History Option port added in Version 4.1
severity severity-level Logs events at a severity level greater than or equal to the level specified.
Specify one of the following:
• emergency—The WSS is unusable.
• alert—Action must be taken immediately.
• critical—You must resolve the critical conditions. If the
conditions are not resolved, the WSS can reboot or shut
down.
• error—The WSS is missing data or is unable to form a
connection.
• warning—A possible problem exists.
• notice—Events that potentially can cause system
problems have occurred. These are logged for diagnostic
purposes. No action is required.
• info—Informational messages only. No problem exists.
• debug—Output from debugging.
local-facility facility-
level
For messages sent to a syslog server, maps all messages of the severity
you specify to one of the standard local log facilities defined in
RFC 3164. You can specify one of the following values:
• 0—maps all messages to local0.
• 1—maps all messages to local1.
• 2—maps all messages to local2.
• 3—maps all messages to local3.
• 4—maps all messages to local4.
• 5—maps all messages to local5.
• 6—maps all messages to local6.
• 7—maps all messages to local7.
If you do not specify a local facility, WSS Software sends the messages
with their default WSS Software facilities. For example, AAA messages
are sent with facility 4 and boot messages are sent with facility 20 by
default.
enable Enables messages to the specified target.
disable Disables messages to the specified target.