Hub/Switch Reference Guide

586 System Log Commands
NN47250-100 (Version 02.51)
• set log on page 576
set log
Enables or disables logging of WSS and AP events to the WSS log buffer or other logging destination and sets the level
of the events logged. For logging to a syslog server only, you can also set the facility logged.
Syntax set log {buffer | console | current | sessions | trace} [severity severity-level] [enable |
disable]
set log server ip-addr [port port-number] severity severity-level [local-facility facility-
level]
buffer Sets log parameters for the log buffer in nonvolatile storage.
console Sets log parameters for console sessions.
current Sets log parameters for the current Telnet or console session. These
settings are not stored in nonvolatile memory.
server ip-addr Sets log parameters for a syslog server. Specify an address in dotted
decimal notation.
sessions Sets the default log values for Telnet sessions. You can set defaults for the
following log parameters:
• Severity
• Logging state (enabled or disabled)
To override the session defaults for an individual session, type the set log
command from within the session and use the current option.
trace Sets log parameters for trace files.
port port-number Sets the TCP port for sending messages to the syslog server. You can
specify a number from 1 to 65535. The default syslog port is 514.